Ferm JSM1018 Gebrauchsanweisung Seite 6

GB
Dust collection
Wear a dust mask. Working with wood, metals and other materials may
produce dust that is harmful to health. Do not work with material containing
asbestos!
Hard materials such as steel, aluminium, plastic.
Soft materials such as wood.
Accuracy.
Faulty and/or discarded electrical or electronic apparatus have to be collected
at the appropriate recycling locations.
Special safety instructions
Before using the appliance:
• Check the following points:
• Does the voltage of the motor (230 V) correspond with the mains voltage?
• Are the feeder cable and plug in good condition: sturdy, without loose bits or
damage?
• Has the saw blade lost any teeth and is it showing cracks or fractures?
• If so, replace the saw blade immediately.
• Is there enough room under the workpiece so that the saw blade does not come
into
contact with the floor or work table as it moves up and down?
• Do the teeth of the saw blade point upwards?
• Always wear protective goggles when using the appliance.
• Maintain the appliance carefully.
• Do not use the appliance in a wet environment.
• Do not use the appliance for material which contains asbestos.
• Never leave the jigsaw unattended.
Check that the switch is not interlocked in the 'On' position
Using the appliance
• Clamp the workpiece that you will be sawing in firmly into place.
• Remove any wood residue that is near or stuck to the surface of the saw blade; do
not use your hand for this. Switch the appliance off before removing any residue!
• Always switch the jigsaw on in idle, i.e. switch the jigsaw on before bringing it into
contact with the workpiece.
• When sawing the wood watch out for knots, nails, cracks and/or dirt deposits.
06 Ferm Ferm
DK
115