Intended Use; Inserting/Replacing The Saw Blade; Initial Operation - Bosch GST 100 CE Bedienungsanleitung

Insert the mains plug only when the machine is
switched off.
Always direct the cable to the rear away from
the machine.
Apply the machine to the workpiece only when
switched on.
The cutting path must be free of obstacles both
above and below.
When sawing, the complete surface of the
base plate 11 should securely rest on the ma-
terial. For the working of smaller or thin work-
pieces, use a stable foundation or a saw table
(accessory).
When the cut is completed, switch off the ma-
chine and then pull the saw blade out of the cut
only after it has come to a standstill (danger of
kick-back).
Always switch off the machine and allow to
come to a stop before placing it down.
Do not brake the saw blade to a stop by apply-
ing side pressure after switching off.
Use only sharp, flawless saw blades. Change
any cracked, bent or dull saw blades immedi-
ately.
Never allow children to use the machine.
Bosch is only able to ensure perfect function-
ing of the machine if the original accessories
intended for it are used.

Intended Use

The machine is intended for making separating
cuts and cut-outs in wood, plastic, metal, ceramic
plates and rubber while resting firmly on the
workpiece. It is suitable for straight and curved
cuts with mitre angles to 45°. The saw blade rec-
ommendations are to be observed.
Inserting/Replacing the Saw
Blade
Before any work on the machine itself, pull
the plug from the socket!
When inserting and changing the
saw blade 5 we recommend wear-
ing protective gloves.
13 • 2 609 932 100 • 09.01
Insert the saw blade (teeth in cutting direction)
until it latches in the stroke rod. When inserting
the saw blade, take care that the back of the saw
blade rests in the groove of the guide roller 6.
4
To change the saw blade, push the SDS lever 7
to the front to the stop; this releases the saw
blade and it is ejected (see Fig.
When changing the saw blade, the ma-
chine should be held so that no persons
or animals can be injured by the ejec-
tion of the saw blade.

Initial Operation

Check for correct mains voltage: The voltage
of the power source must agree with the voltage
specified on the nameplate of the machine.
Equipment marked with 230 V can also be con-
nected to 220 V.
Switching On/Off
GST 100 B/BCE:
Brief activation
Switching on: Press ON-OFF switch 10.
Switching off: Release ON-OFF switch 10.
Continuous use
Switching on: Press ON-OFF switch 10 and re-
Switching off: Press
GST 100/CE:
Switching on: Slide the on/off switch 10 to the
Switching off: Press the on/off switch 10 at the
English - 2
Note: If the saw blade
cannot be inserted into
the stroke rod 4 be-
cause the slots of the
saw blade holder are
not in the position as
shown, push the SDS
lever briefly to the front
and release.
A
tain with locking button 15.
and release
switch 10.
front until it latches (Position
I = ON).
rear; the switch springs back to
the initial position
0 = OFF).
).
ON-OFF
(Position