Dismounting, Return And Disposal; Dismounting; Return - WIKA CPU6000-W Betriebsanleitung

9. Faults / 10. Dismounting, return and disposal
CAUTION!
If faults cannot be eliminated by means of the measures listed above, shut
down the CalibratorUnit immediately, ensure that pressure is no longer
present, and secure the instrument from being put back into operation
inadvertently.
In this case, contact the manufacturer.
If a return is needed, follow the instructions given in chapter 10.2 "Return".

10. Dismounting, return and disposal

WARNING!
Residual media on the test item and/or sensors of the CalibratorUnit
can result in a risk to personnel, the environment and equipment. Take
sufficient precautionary measures.

10.1 Dismounting

Only disconnect test and calibration installations once the system has been depressurised!

10.2 Return

WARNING!
Strictly observe the following when shipping the instrument:
All instruments delivered to WIKA must be free from any kind of hazardous
substances (acids, bases, solutions, etc.).
When returning the instrument, use the original packaging or a suitable transport
packaging.
To avoid damage:
1. Wrap the instrument in an antistatic plastic film.
2. Place the instrument, along with shock-absorbent material, in the packaging. Place
shock-absorbent material evenly on all sides of the transport packaging.
3. If possible, place a bag containing a desiccant inside the packaging.
4. Label the shipment as carriage of a highly sensitive measuring instrument.
WIKA operating instructions CalibratorUnit, model CPU6000
EN
37