Maintenance; Prolonged Periods Of No Use; Faults, Alarms And Breakdowns - Fagor F-G9115 Installations-, Gebrauchs- Und Wartungsanleitung

Lastly, dry the vat.
5.3.2

Maintenance

FAGOR INDUSTRIAL recommends a service of all the operating components of the fryer at least once a
year to check their condition and the correct operation of the appliance. This service must be carried out
by an OFFICIAL AND/OR AUTHORISED TECHNICAL SERVICE.
The replacement of any functional component that may affect the safety of either the appliance or the
user should be performed by an OFFICIAL AND/OR AUTHORISED TECHNICAL SERVICE, using the
appropriate original spare parts.
Always clean the machine correctly to prolong the service life of the machine.
•
Remove any waste from the machine at the end of each day.
•
Do not use abrasive, corrosive or acid products, chlorine-based detergents, solvents or petrol
derivatives to clean the machine.
•
Do not use pressurised water to clean the machine.
•
It is advisable to periodically clean the inside of the tank with a solution of water and detergent,
which should be allowed to boil slowly for a few minutes. Then use a scrub brush to scrub and
remove any residue from the tub. Finally, rinse with plenty of water and dry. To be able to clean
the tank beforehand, it is necessary to evacuate the baskets and the grid and raise the heating
elements
If the power cable is damaged, it must be replaced by the manufacturer, after-sales service or authorised
technical personnel in order to prevent risks.
5.3.3

Prolonged periods of no use

If the machine is kept out of service for a long period of time (holidays, temporary closure, ...), please
observe the following:
•
Close the gas supply.
•
Clean the machine and the adjacent areas thoroughly.
•
Leave the door of the machine open.
•
Sprinkle a thin layer of edible oil on the stainless steel surfaces.
•
Switch off the mains power supply.

6. FAULTS, ALARMS AND BREAKDOWNS

The steps to be followed in the event of a fault or operating error are described below. The possible causes and
possible solutions are listed in the following table. In the event of doubt, or if you are unable to resolve the problem,
please contact the technical service.
Do not handle electrical components, as there is a risk of death as the components are
live.
32