Installation Instructions; Removal Of Packaging; Positioning And Levelling; Assembly Of Equipment In Blocks - Fagor F-G9115 Installations-, Gebrauchs- Und Wartungsanleitung

ACCESSORIES ON ORDER
Fagor Industrial offers the following accessories for the fryer (not supplied with the equipment) which are available
on order:
•
CODE: Small basket kit for 15 l vat.
•
CODE: Large basket KIT for 21 l vat.

4. INSTALLATION INSTRUCTIONS

The positioning and installation, and all repairs or modifications, should always
be carried out by an AUTHORISED TECHNICIAN, in accordance with the
applicable legislation of the country.
The installation, incorrect adjustment, inappropriate maintenance or use of the
appliance may cause material damages and injuries.

4.1 Removal of packaging

Remove packaging from the machine and check for damage during transportation. If any damage is
observed, immediately notify the supplier and the transport company. In the event of doubt, do not use
the machine until the problem has been assessed.
Packaging (plastic, wood, staples, etc.) must not be left in the reach of children, it is a
potential hazard.
The machine should be moved using a fork-lift truck or similar to avoid damage to the structure. Transport
the machine to the installation location and then remove packaging.
All the packaging can be recycled. Dispose of packaging correctly.

4.2 Positioning and levelling

This machine has adjustable legs to ensure that it is always correctly mounted. Just rotate the legs until
the required height. For optimum operation, it is essential that the machine is correctly levelled. The
flooring on which the machine is to be installed must be able to bear the full weight of the machine.
it is advisable to install an extraction hood for the optimum operation of the appliance.
Place the appliance in a sufficiently ventilated room, in accordance with the current regulations, to prevent
the formation of unacceptable concentrations of harmful substances in the installation site.
If the wall is not able to withstand temperatures of 150 ºC, the appliance should be installed at a distance
of at least 100 mm. Appliances must only be installed on and/or against fireproof surfaces.
Inspect final location of the machine prior to installation to prevent damage during use.
Unless otherwise indicated, the parts that have been protected by the manufacturer must not be
manipulated by the installer.

4.3 Assembly of equipment in blocks

To assemble the equipment in blocks, proceed as follows:
•
Remove the controls.
•
Dismount the control holder panels.
•
Remove the chimney trim.
•
Place adhesive tape around the edges of the worktop to be joined.
•
Apply sealant suitable for use in zones in contact with food on the sides to be joined.
•
Join the machines together.
27