Startup; Cleaning And Maintenance Instructions; Cleaning And Sanitizing Instructions - Hoshizaki KM-590DJE-R452 Bedienungsanleitung

I. Startup
WARNING
1. All parts are factory-adjusted. Improper adjustments
may adversely affect safety, performance, component
life, and warranty coverage.
2. If the icemaker is turned off, wait for at least 3 minutes
before restarting the icemaker to prevent damage to
the compressor.
3. To prevent damage to the water pump, do not leave
the control switch in the "WASH" position for extended
periods of time when the water tank is empty.
4. On remote air-cooled model, the icemaker should
have power for a minimum of 4 hours prior to startup to
prevent compressor damage.
5. At startup, confirm that all internal and external
connections are free of leaks.
1) Open the water supply line shut-off valve(s).
2) Remove the front panel.
3) Move the control switch on the control box to the "ICE"
position.
4) Replace the front panel in its correct position.
5) Turn on the power supply, and allow the icemaker to
operate for a total of 10 minutes.
6) Turn off the power supply, then remove the front panel.
7) Remove the insulation panel. Remove the drain plug
located on the lower front part of the ice chute. See
Fig. 10. Allow the water tank to drain.
8) Replace the drain plug, insulation panel, and front panel in
their correct positions. Be careful not to cross thread the
drain plug.
9) Clean the storage bin liner using a neutral cleaner. Rinse
thoroughly after cleaning.
10) Turn on the power supply to start the automatic icemaking
process.
11) To confirm bin control operation, press and hold the
bin control's actuator paddle during the first 5 minutes
of the freeze cycle. The icemaker should shut down in
approximately 15 seconds.
Ice Chute Float Switch Assembly
Fig. 10
III. Cleaning and Maintenance
Instructions
This icemaker must be cleaned and maintained in
accordance with the documentation and labels provided
with the icemaker. Consult with your local distributor about
cleaning and maintenance service. To obtain the name and
phone number of your local distributor, contact your nearest
Hoshizaki Service office.
1. Except as specified below, only qualified service
technicians should attempt to service this icemaker.
2. CHOKING HAZARD: Ensure all components,
fasteners, and thumbscrews are securely in place after
any cleaning or maintenance is done to the unit. Make
sure that none have fallen into the storage bin.
3. This appliance must not be cleaned by use of a water jet.
4. To prevent possible damage, do not clean the plastic
parts with water above 40°C or in a dishwasher.
5. The storage bin is for ice use only. Do not store
anything else in the storage bin.
A. Cleaning and Sanitizing Instructions
Performed by Qualified Service
Technician
Hoshizaki recommends cleaning and sanitizing this unit at
least once a year. More frequent cleaning and sanitizing,
however, may be required in some existing water
conditions.
1. To prevent injury to individuals and damage to the
icemaker, do not use ammonia type cleaners.
2. Carefully follow any instructions provided with the
bottles of cleaning and sanitizing solution.
3. Always wear liquid-proof gloves and goggles to
prevent the cleaning and sanitizing solutions from
coming into contact with skin or eyes.
4. To prevent damage to the water pump seal, do not
operate the icemaker with the control switch in the
"WASH" position when the water tank is empty.
Drain Plug
12
ENGLISH
WARNING
WARNING