Adjustment Of The Magnify Tonearm; Adjustment Of The Vta - Clearaudio Magnify Bedienungsanleitung

User manual / Bedienungsanleitung
5. Adjustment of the
The following settings require to mount the cartridge on the headshell.
Always follow the cartridge manufacturer's instructions.
Leave the stylus protector on your cartridge to avoid any damages!
Now you can connect the respective signal cable with the matching color pins of the cartridge.
Please note the following colour coding:
Red:
right channel / R+
Green:
right channel / R-
White:
left channel / L+
Blue:
left channel / L-
Connect the pins of your cartridge to the jacks of the headshell or tonearm cable, taking care not
to use too much force. If necessary, you can use suitable precision pliers or tweezers for assistance.
Pic. 11: Adjustment of the VTA
Please be extremely careful during the following steps!
Never move the cartridge in the alignment gauge while it is lowered.
Use the lift to lower the tonearm and check if the tonearm tube is parallel to the platter.
The tonearm tube should not touch the lift bracket, but the needle must rest on the record or the
alignment gauge.
If the tonearm tube is not parallel, but shows a slight incline, put the tonearm tube back in the rest
position. Now carefully lower/raise the entire tonearm in the clamping ring so that the tonearm tube
is parallel to the platter.
While the tonearm is in this position you can hand-tight the clamping ring.
If the position is still correct, you can put the tonearm back in the rest position holder and put the
stylus protector back on.
Made in Germany
Magnify
tonearm

5.1 Adjustment of the VTA

The tonearm remains loose in the clamping ring and is not
screwed tight. Now place a record or the Clearaudio alignment
gauge (Art. No. AC005/IEC) on the turntable and remove the
stylus protector from your cartridge.
Make sure that the tracking force is roughly adjusted in order
not to damage the cartridge.
Page / Seite 11