Adjustment Of Tonearm; Adjustment Of The Tangential Alignment - Clearaudio TT3 Bedienungsanleitung

User manual / Bedienungsanleitung
7. Fine adjustment of the tonearm

7.1 Adjustment of the tangential alignment

Use the lift to lower the stylus at the left hand end of the Clearaudio linear gauge, moving the
gauge so that the diamond sits exactly on the reference line (see Pic. 22, red line). Lift the cartridge
up again and then position it at the right hand end of the gauge.
Pic. 22a: Adjustment of the linear tracking
Pic. 22: Adjustment of the linear tracking
Important note:
To avoid any damage, never move the cartridge while it is lowered in the linear gauge.
If the cartridge is not parallel to the reference line, rotate the tonearm base in the appropriate
direction, fix it in place and recheck your result.
Repeat this process until the stylus exactly follows the reference line of the linear gauge.
Finally, hand-tighten the screw/screws of the tonearm base to fix the final adjustment.
© clearaudio electronic GmbH, 2022-01
Page / Seite 14