Herunterladen Inhalt Inhalt Diese Seite drucken

Warranty And Liability; Material Defects; Technical Terms; Delivery, Internal Transport And Unpack - LORCH EC-Clean 1000R Bedienungshandbuch

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Delivery, internal transport and unpacking
11

Warranty and liability

Warranty and liability claims for personal injury and property
damage are excluded if the damage is due to one or more of
the causes listed below:
Non-intended use
– of the components belonging to the device.
– of the chemicals belonging to the electrochemical
processing device.
– due to the use of unsuitable chemicals.
– due to the use of non-approved accessories.
Non-compliance
– with the working and safety instructions in these
instructions.
– with the operating instructions of the device or com-
ponents.
Improper
– initial set-up of the device.
– initial set-up of the device when the guards are not
properly fitted.
– operation of the device.
– maintenance of the device.
– repairs carried out on the device.
– repair by unqualified personnel.
Use
– of the device in living rooms and offices.
– of the device in an environment with a fire or explo-
sion hazard.
– of the device in a humid environment.
– of an unauthorised structural modification of the
device.
Non-compliance
– with the prescribed maintenance intervals.
Absolutely no claims of any kind can be made
i
i
against Lorch Schweißtechnik GmbH for dam-
age and faults caused by operating the device
with components and chemicals from other
manufacturers
unless it is clearly proven that the damage
clearly resulted from negligent design or man-
ufacture by Lorch Schweißtechnik GmbH and
was foreseeable at the time of design.
11.1

Material defects

The purchaser must immediately notify the supplier in writing
of any material defects within 14 days.
If no limitation periods for material defect claims have been
agreed between the supplier and the consumer, the statutory
provisions shall apply.
In the case of a material defect claim, submit a certificate
showing that the limitation period has not been exceeded.
05.22
12

Technical terms

Distilled water
Distilled water contains no minerals and is therefore very
"soft". It is obtained by distillation.
Demineralised water
Demineralised water is obtained by filtration. It contains hard-
ly any minerals and is also very "soft".
Electrolyte
Electrolytes are electrically conductive chemicals used to
clean welds.
Carbon fibre brush
Carbon fibre brushes consist of up to 1.5 million individual car-
bon fibres. During the cleaning process, the current is distrib-
uted over the individual fibres.
A small arc (~3 - 7 µm in size) forms on each fibre that comes
into contact with the workpiece surface.
Passivation
Passivation is the inactivation of oxidation processes on the
workpiece surface through chemical treatment.
Water hardness
The mineral content in the water determines the degree of
hardness.
The higher the concentration of certain minerals in the water,
the higher the degree of hardness.
The degree of hardness is specified in "degrees of German
hardness" (°dH).
13
Delivery, internal transport and
unpacking
The complete set of equipment is delivered in a sturdy plastic
Euro box.
This box is sealed at our factory with two plastic cable ties and
one metal cable tie before shipping.
The cover can only be opened by destroying and removing
the cable ties.
As a matter of principle, all activities required
for delivery, transport, unpacking and storage
must be carried out with the utmost care and
all rules and regulations required for safety
must be observed.
Failure to follow the safety rules and regula-
tions can result in serious cuts, bruises and bro-
ken bones.
13.1

Delivery

The equipment set is delivered in a plastic Euro box.
909.4609.9-00
- 29 -

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis