Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7. Network Scan
The SECACAM Explorer automatically connects to the strongest network
available. If you should not be happy with your network connection however,
you can start a manual network scan. This might take some time.
1.
SETUP:
2.
Right Arrow:
work Connection.
3.
Right Arrow+Left Arrow:
bottun at once and wait until you can read "Done" on the screen.
Should a stronger network be available, your camera will connect
to it.
The SECACAM is now connected with the best net avaivible. If there
shouldn't be a stronger possible connection, the camera will relog into the
network it was loged in before.
8. Manual Test Photos
To manually adjust the the photo quality, you can take a test photo:
1.
SETUP: Switch the camera to the SETUP option. Once the monitor
is on and the start-up screen has finished, you can see the photo
preview. Here you can see the area your camera is monitoring.
2.
OK = Aufnahme:
Note: Depending on the "mode" setting either a photo or a video is re-
corded. In the video mode the recording is stopped after 15 seconds.
60
Wait for the camera to fully boot.
You are now shown the details of your current Net-
Press "OK" to take a photo or a video manually.
7. Nerwork Scan & 8. Test Photo
Hold down both the left and right arrow
Werbung
Inhaltsverzeichnis
