ATIKA ALA 2500 Originalbetriebsanleitung Seite 18

Before each fault elimination:
− Switch off device.
− Wait for standstill of the device.
− Pull out mains plug.
Fault
Motor does not start
Motor hums but does not
start
Shredding material is not
drawn into the shredder
Shredding material not cut
cleanly
Device starts but blocks
under as slight load and
switches off via protective
motor switch.
Please observe the enclosed terms of guarantee.
18
O p
O p
Possible cause
- No power supply
- Mains cable defective
- Machine overloaded (motor protection)
- Cutting roller blocked
- Capacitor faulty
- The cutting roller is running in reverse.
Wrong switch position
- Shredding material caught in funnel
- Shredding material too soft or wet
- Cutting roller worn
- Fixed counter blade not adequately ad-
justed
Extension cable too long or cross-section to
small.
Socket too far from mains supply and cross-
section of mains cable too small
e r a t i o n a l f a u l t s
e r a t i o n a l f a u l t s
Remedy
- Check fuses
- have these checked (electrician)
- Allow the device to cool down.
Press the
1. reset button (motor protection)
2. green button
- Switch off the device.
Turn the direction of rotation selector switch into
position
cleared. Switch device off again. Turn back the
direction of rotation selector switch to position .
- Bring machine to manufacturer or authorised work-
shop for repair
- Switch off device and switch over direction of rotation
selector switch.
- Switch off device. Switch the direction of rotation
selector switch into position
release the material to be shredded, remove any
foreign matter.
Switch off device again. To continue work, place the
direction of rotation selector switch back into position
.
- Push down with a branch and shred
- Adjust fixed counter blade as described under „adjust-
ing the fixed counter blade". In case of severe wear,
replace cutting roller.
- Adjust fixed counter blade
Extension cable at least 1.5 mm², maximum 25 m long. If
a longer cable is used, minimum cross-section 2.5 mm².
G u a r a n t e e
G u a r a n t e e
to restart.
. Switch on device until the jam has been
. Switch on device to