Hitachi PC-ARFP1E Installations- Und Betriebshandbuch Seite 41

TEST RUN MENU
6.12 POWER UP SETTING
This function is used to set the maximum compressor frequency
and the target compressor frequency higher than usual. Power
up operation is performed after starting operation in the selected
operation mode (COOL only - HEAT ONLY - COOL+HEAT).
1 Press and hold " " (menu) and "
simultaneously for at least 3 seconds during the normal
mode (when unit is not operated). The test run menu will be
displayed.
Test Run Menu
Priority Setting
Power Up Setting
Setback Trigger Unit
Cancel Preheating Control
Contact Information
Sel.
ADJ
2 Select "Power up setting" from the test run menu pressing
" " and "OK".
3 Press " " to switch to select between "COOL only - HEAT
only - HEAT + COOL" and press "OK" .
6.13 SETBACK TRIGGER UNIT
This function is used to change trigger unit.
1 Press and hold " " (menu) and "
simultaneously for at least 3 seconds during the normal
mode (when unit is not operated). The test run menu will be
displayed.
Test Run Menu
Priority Setting
Power Up Setting
Setback Trigger Unit
Cancel Preheating Control
Contact Information
Sel.
ADJ
2 Select "Setback trigger unit" from the test run menu pressing
" " and "OK".
3 Select the indoor unit by pressing "
*This screen is not displayed when the number of indoor
units connected with the remote control switch is 1 (one). In
this case, (4) will be displayed.
Setback Trigger Unit
01-01 02-01
01-02 02-02
01-03 02-03
01-04
02-04
Sel.
ADJ
33 PMML0496 rev.1 - 12/2020
" (return / help)
/ ?
03
/
03
OK Entr Rtrn
/ " (return / help)
?
03
/
03
OK Entr Rtrn
" and press "OK".
03-01 04-01
03-02 04-02
03-03 04-03
03-04 04-04
OK
Entr Rtrn
Power up setting
Power up
LOUV.
T-RUN TIME
Adj.
4 Select "Yes" and press "OK". The test run menu will be
displayed after the setting is confirmed. If "No" is pressed,
the screen will return to step 3.
Power up setting
Confirm Power Up?
Yes
Sel.
5 Press " " (return / help) on the test run menu to return to the
normal mode.
?
N O T E
Power up setting is only available when using outdoor units
RAS-(3-12)H(V)NC1(E) and RAS-(4-6)FS(V)NME series.
4 Press " " to switch to select "Yes" and press "OK" to set
trigger unit. Step 5 is shown. Select "No" to return to "3".
Setback Trigger Unit: 01-01
Set this unit as trigger unit?
Yes
Sel.
5 Press "OK" switch to return to "1".
Setback Trigger Unit: 01-01
Completed.
Sel.
?
N O T E
• If 2 remote controllers are connected, Trigger Unit Setting is available
only on Primary remote controller.
• Child unit without transmission wiring cannot be set as trigger unit.
• For the first start up, the indoor unit with the smallest refrigerant cycle
and address number is set as trigger unit by default.
COOL only
120MIN
OK Entr Rtrn
No
OK Entr Rtrn
No
OK Entr Rtrn
OK
OK
Entr Rtrn