Hitachi PC-ARFP1E Installations- Und Betriebshandbuch Seite 28

TEST RUN MENU
Element Optional function
Not used
K4
Detection level of the
K5
motion sensor kit
Selection of allowed
operation modes when
the control sensor of the
K6
indoor unit is set by C8
function
Not used
K7
Control for the
prevention of
K8
condensation on the
louvres.
Not used
K9
Not used
KA
Not used
L1
Not used
L2
20 PMML0496 rev.1 - 12/2020
Individual
Settings
setting
00
01
- -
02
03
Standard (factory setting)
00
O High
01
Low
02
All modes allowed
00
Only cooling/dry allowed
01
O
Only heating allowed
02
All modes allowed
03
00
01
- -
02
03
Function disabled
00
(factory setting)
O
Function enabled
01
00
- -
01
00
- -
01
00
01
- -
02
03
00
01
- -
02
03
Setting conditions
Use at 00 conditions
Models:
RPF(I)-FSN2E
Not available, use at 00 conditions.
This parameter defines the
sensitiveness of the motion sensor.
The amount of activity in the room
is assessed according to a different
scale based on this setting.
Detailed information about the
operation of the motion sensor can be
found in the technical documentation
of the indoor units.
This function is used to select the
operation modes in which the setting
of C8 (use of remote control switch
sensor or remote sensor on THM4 to
control the indoor unit) is enabled.
Use at 00 conditions
Condensation may occur around air
outlet during COOL/DRY operation
with horizontal air flow or downward
air flow for long periods.
This function is used to prevent
condensation by moving the
louvre swing angle to the third step
automatically for 30 minutes every 1
hour.
(In RPK units, this function is
activated by means of DSW2-4
instead of the K8 optional function)
Use at 00 conditions
Use at 00 conditions
Use at 00 conditions
Use at 00 conditions
Description