Hitachi PC-ARFP1E Installations- Und Betriebshandbuch Seite 25

TEST RUN MENU
Element Optional function
Automatic reset of
F3
setting temperature
Automatic reset time
F4
Automatic reset
F5
temperature for cooling
Automatic reset
F6
temperature for heating
Prevention of operation
stoppage due to wrong
F7
operation of the remote
controller
Lock function for
operation mode
F8
selection
Lock function for
F9
temperature setting
Lock function for fan
FA
speed selection
Lock function for swing
Fb
louvre operation
17 PMML0496 rev.1 - 12/2020
Individual
Settings
setting
Function disabled
00
(Factory setting)
X
Function enabled
01
30 minutes (factory setting)
00
15 minutes
01
X
60 minutes
02
90 minutes
03
19 °C
19
20 °C
20
21 °C
21
·
·
·
·
·
·
24 °C
24
25 °C (factory setting)
X
25
26 ºC
26
·
·
·
·
·
·
28 ºC
28
29 ºC
29
30 ºC
30
17 ºC
17
18 ºC
18
·
·
·
·
·
·
20 ºC
20
21 ºC (factory setting)
21
X
25 ºC
25
·
·
·
·
·
·
28 ºC
28
29 ºC
29
30 ºC
30
Function disabled
00
(factory setting)
X
Function enabled
01
Function disabled
00
Function enabled
X
01
(factory setting)
Function disabled
00
Function enabled
X
01
(factory setting)
Function disabled
00
Function enabled
X
01
(factory setting)
Function disabled
00
X Function enabled
01
(factory setting)
Setting conditions
This function is used to limit unit
operation and save energy.
The setting temperature is
automatically set to the value defined
with functions "F5" or "F6", according
to the current operation mode, after
the time set with function "F4" has
passed since the last manual change
of setting temperature.
In case that the values of "F5" or "F6"
are out of the limits set with functions
"FC" and "Fd", limitations set by "FC"
and "Fd" have priority.
This function sets the automatic reset
time delay for function F3.
This function defines the default
temperature set point for the
automatic reset function F3 in FAN/
COOL/DRY modes.
This function defines the default
temperature set point for the
automatic reset function F3 in HEAT
mode.
Operation is stopped by pressing the
run/stop switch for 3 seconds.
This function is used to prevent
changes to the operation mode.
This function is used to prevent
changes to the temperature setting.
This function is used to prevent
changes to the fan speed.
This function is used to prevent
changes to the automatic louvre
operation.
Description