General product maintenance
Make sure that the dust hoses are not damaged and free
of blockage.
Make sure that the dust collector is empty and connected
correctly.
Do a check of the burnishing pad.
Do a check of the brush strip.
Make sure that the power cord and extension cable are
in good condition and not damaged.
Do a complete servicing and cleaning of the product.
Clean the product with a damp cloth.
Do a check of the coupling.
To clean the product
•
Always clean all the equipment after use. Use a
vacuum cleaner.
•
Do not use a high-pressure washer to clean the
product.
•
Keep the air openings clean and clear to make
sure that the product always has sufficiently cool
temperature.
•
Clean the brush strip with water. Make sure that the
remaining mixture of dust and water is fully removed.
To do a check of the brush strip
•
Make sure that the brush strip is not damaged and
that it seals tightly against the floor.
To replace the burnishing pad
WARNING:
parts are fully stopped.
1. Disconnect the product and remove the dust
extractor hose.
1823 - 003 - 13.04.2022
Make sure that all moving
Daily
Weekly
*
*
*
X
*
X
2. Tilt the product.
3. Put the product down on the rear supports.
Each 3
Yearly
months
O
*
31