Symbols On The Product - Husqvarna BB 700 Bedienungsanweisung

13. Power connection
14. Electrical enclosure
15. Operator presence control (OPC)
16. Operator's manual
Product overview, keypad
1
14
13
12
11
10
1. Product status
• "RDY" (ready): the product can be used.
• "STO" (safety stop): the product has no input on
the STO contact.
• "ACC" (acceleration): the burnishing disc speed
increases to the set value.
• "DEC" (deceleration): the burnishing disc speed
decreases to the set value or until the product
stops.
• "NST" (freewheel stop): the movement of the
product stops.
2. Command channel
• "Term": motor is stopped.
• "HMI": motor is started.
3. Main voltage for the burnishing motor
4. Electrical current for the burnishing motor
5. Burnishing disc speed
6. Button to increase burnishing disc speed
7. Home button
8. Info button
9. Start button
10. Speed adjustment for burnishing disc
11. Stop button
12. Button for direction of rotation of the burnishing disc
13. Button to open the menu system
14. Button to decrease burnishing disc speed
1823 - 003 - 13.04.2022
3
2
4

Symbols on the product

5
6
7
8
9
Note:
Other symbols/decals on the product refer to
special certification requirements for some markets.
Warning: This product can be dangerous
and cause serious injury or death to the
operator or others. Be careful and use the
product correctly.
High voltage.
Lifting point on the product.
Read the manual carefully and make
sure that you understand the instructions
before you use the product.
Use an approved respiratory protection.
Use approved hearing protection.
Use approved eye protection.
Use approved protective gloves.
Use approved protective boots.
This product is in compliance with
applicable EU directives.
23