Herunterladen Inhalt Inhalt Diese Seite drucken

To Clean The Product - Husqvarna PG 830S Bedienungsanweisung

Vorschau ausblenden Andere Handbücher für PG 830S:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Maintenance
Do a check of the attachment points and the lock function for the
weights.
Do a check of the emergency stop button.
Clean the external surfaces of the product.
Clean the internal components of the product.
Do a general inspection.
Do a check of the grinding discs.
Do a function check of the drive system for the grinding head.
Do the service on the drive system for grinding discs.
Do a check of the connection between chassis and grinding head.

To clean the product

CAUTION:
decreases the performance of the product
and can cause the motor to become too hot.
Remove blockage from all air openings. The product
must always have sufficiently cool temperature.
Always disconnect the power plug from the mains
outlet before you clean.
Do not use chemicals to clean the product.
Do not clean electrical components with water.
Always clean all the equipment at the end of the
work day.
a) Tilt the product until the handlebar is on the floor.
b) Remove the diamond tools and operate the
product for a short period at the lowest speed.
Operate the product to decrease the quantity of
dust at the top surface of the grinding head.
c) Clean the components at the bottom surface of
the grinding head with a high-pressure washer.
CAUTION:
high-pressure washer directly at
seals or connection points.
To do a general inspection
Make sure that the power cord and extension cable
are in good condition and not damaged.
Make sure that nuts and screws are tight.
18
A blocked air intake
Do not point the
Daily
X
X
X
X
Make sure that the head locks are tight. If it
is necessary, tighten the head locks and use
®
LOCTITE
680 threadlocker.
To do a check of the grinding discs
Examine the spring steel spring for damages and
make sure that it is in good condition.
Replace damaged spring steel springs.
Note:
It is not necessary to discard the grinding
disc when you replace the spring steel spring.
Each
Each 6
Weekly
12-36
months
months
*
O
X
*
1253 - 004 - 09.12.2022
O

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis