Data Sheet - MA lighting 2Port Node Bedienungsanleitung

Technischer Service: tech.support@malighting.com; +49.5251.688865-30 Emergency Line: +49.5251.688865-99
MA Lighting Technology GmbH . Dachdeckerstr. 16 . D-97297 Waldbüttelbrunn

Data sheet

Dimensions: see chapter 6
Weight: Flush mount version
Rigg mount touring version
Power supply: Flush-mount Version:
PowerOverEthernet, no additional supply necessary
Rigg-mount Version:
PowerOverEthernet and
100 - 240 V AC , 50 - 60 Hz (no switch over necessary)
Power consumption: approx. 2 Watt (in PowerOverEthernet - mode)
approx. 15 Watt (Rigg-mont version with external power supply)
Fuse: T1A , L 250V (only Rigg-mount Version)
Protection Classification: In normal operating status IP40 in compliance with
(only Rigg-mount Version) DIN EN 60529 and DIN 40050 Part 9
Protection class: In normal operating status class1
(only Rigg-mount Version)
DMX-Output / Input
The DMX input is protected against over-voltage with additional suppressor diodes and complies with
the RS485 or RS 422a standard.
Pin assignment: pin 1 = earth (not connected to ground)
pin 2 = Data -
pin 3 = Data +
Please note that all DMX devices are connected "in series" and that you cannot build y connections.
The DMX line has to be terminated by a 100 terminal resistance between pin 2 and 3.
Make the settings for DMX address etc. in the respective
0,160 kg without accessories
1,100 kg without accessories
pin 4 = not assigned
pin 5 = not assigned
menus..
60 60 60 60
60