Save / Load Configuration - MA lighting 2Port Node Bedienungsanleitung

Technischer Service: tech.support@malighting.com; +49.5251.688865-30 Emergency Line: +49.5251.688865-99
MA Lighting Technology GmbH . Dachdeckerstr. 16 . D-97297 Waldbüttelbrunn
SAVING the configuration
You can save the 2Port settings either in the Showfile, on the harddisk of the console or
externally (on floppy).
press the SAVE CONFIG button
Use CANCEL, to abort the procedure, or OK to save the configuration to the Showfile. You
can load this Snapshot only within this Show!
NOTE: SAVE SHOW will not save the settings; you have to save them separately with SAVE
CONFIG.
This will bring up the next query:
Abort with Cancel (only the Snapshot will be stay saved).
Use OK, to save the configuration to the harddisk or on a floppy.
- Press on HardDisk and chose Harddisk or Floppy.
Enter the name of the configuration file and confirm with ENTER. If you select an existing
Config file, this will be overwritten.
Loading the configuration
Load the Snapshot: (only possible in the same Show, to which the Snapshot had been saved).
Press the LOAD CONFIG button Do not select a file in the main menu – the blue cell
is empty.
Close the menu (press X).
Press the OK button.
or
Load the configuration:
Press the LOAD CONFIG button. In the main menu, chose HardDisk or Floppy and select
a file.
If applicable, insert a floppy and confirm with ENTER.
Use CANCEL to abort or OK to load the configuration.
If you have integrated additional 2Ports into the Show or exchanged a 2Port, after having
saving the configuration, these 2Ports will not be taken into account when loading this
configuration (even if the IP address wasn't changed). You will first have to configure these
„new" 2Ports and then create a new configuration file using SAVE CONFIG.
57 57 57 57 57