Update - MA lighting 2Port Node Bedienungsanleitung

grandMA1
grandMA2
Technischer Service: tech.support@malighting.com; +49.5251.688865-30 Emergency Line: +49.5251.688865-99
MA Lighting Technology GmbH . Dachdeckerstr. 16 . D-97297 Waldbüttelbrunn
NOTE:
Make sure not to implement components into the network which would slow down
the transmission rate to 10Mbit.
On consoles with serial numbers higher than those given below, using 2Port Nodes in a
network will not present any problems, as they already have a 100Mbit network controller
and 256MB memory installed:
- grandMA
- grandMA Light
- grandMA UltraLight
- grandMA Replay Unit
Consoles with lower serial numbers must be upgraded to 256MB RAM and receive a
100Mbit network controller

UPDATE

(do not use in live situation)
The 2Port Node can only be updated from a grandMA console or using the onPC software. To
do so, the 2Port Node must be present in the same network as the console (grandMA,
grandMA light, grandMA ultralight, grandMA Micro, Offline or onPC), i.e. the first 3 IP address
groups must be identical. This very console must run the desired software version (5.7 or
higher).
If the cell „version" has a red background, the 2Port Node runs a software version different from
that of the console or onPC. In this case, you have to adapt the software versions as follows:
On the console or in onPC, open the
(grandMA1) TOOLS / MA NETWORK CONFIGURATIONS / 2PORT
(grandMA2) SETUP / NETWORK MASTER / MA NETWORK CONFIGURATION / 2PORT
If the 2Port Node does not appear in the overview (other network number), press the SHOW
ALL button. This will bring up all 2Port Nodes.
Press the UPDATE ALL NODES / SOFTWARE UPDATE button
After an automatic reboot of the 2Port Node, the cell „version" must have a grey background.
NOTE: if the warning "waiting for update" appears in the display, the version update is
unimplemented . Repeat the update
SN 490 and higher
SN 317 and higher
SN 232 and higher
SN 38 and higher
procedure (see above).
56 56 56 56
56