Quick Start - MA lighting 2Port Node Bedienungsanleitung

Technischer Service: tech.support@malighting.com; +49.5251.688865-30 Emergency Line: +49.5251.688865-99
MA Lighting Technology GmbH . Dachdeckerstr. 16 . D-97297 Waldbüttelbrunn

Quick Start:

These are the basic steps to start up the 2Port Node:
Mount the 2Port Node (flush-mount version) in a flush box; install the rig-mounted version using the
fastening screws)
Power supply:
Flush-mount: For this version, the switch / hub must support the PowerOnEthernet function
and must deliver sufficient power (approx. 2 Watt) - not for onPC!
Rigg-mount: Either operate it via PowerOverEthernet and/or plug the supplied mains cord
into the 2Port and connect it to a correctly installed wall socket (100-230V, 50-60Hz). You
can work with both operation modes simultaneously – no need to define or select any; on
power failure, the 2Port will automatically switch over to the available power source.
Install onPC on a PC or laptop computer
or
Switch on the grandMA console (grandMA1 or grandMA2)
Connect the 2Port using a network cable (RJ45 plug). Either via the switch / hub or by directly
plugging it into a PC or laptop computer (not valid for flush-mount version) -
Start a session from the console or in onPC
On the console / onPC open the menu
TOOLS / MA NETWORK CONFIGURTAIONS / 2 PORT
or
SETUP / NETWORK MASTER / MA NETWORK CONFIGURATION / 2 PORT
If needed, set the software version – if the „Version" cell is highlighted in red,
Set the IP-address of the 2Port Node. If there are several 2Port Nodes on the network, you can find
each of them using the IDENTIF button – the display and theLED of the selected Node will blink
Name the 2Port (optional)
Set the mode
Set the session ID (only MANET) - must be identical to the one set on the console or in onPC
Set the ports
Connect the DMX cables
- no cross-cable!
36 36 36 36
36