Beko HCA92640BH Benutzerhandbuch Seite 15

5 Installation of appliance
5.5 Installation of the hood to the
flue
make the electrical connection of your hood be-
fore starting the installation of the flue. Slip the
flue plates around the body. Screw the flue to the
flue fastening plates available on the motor cabin.
(Figure 11).
Install the flue to the flue fastening plate that is
secured to the wall from its upper outer edges
(Figure 11).
(Figure 11)
5.6 Installation of air baffle
While using with the carbon filter, air baffle is pro-
vided with your appliance with the aim of re-re-
leasing the air which is cleaned with carbon filter
from the perforated located on the flue. Assemble
the air baffle as below.
Cooker Hood / User Manual
(Figure 12)
There is a tab in the middle of the flue connection
plate. Place the middle point of this tab on the line
that is drawn perpendicular to the wall. Align hori-
zontally and mark the holes where the connection
plate will be mounted via a pen (Figure 12/A, B).
Drill the marked points with Ø6mm drill and in-
sert two Ø6mm plastic dowels in the drilled holes
(Figure 12/A, B).
Fix the flue connection plate to the wall with
3.9x22 screws (Figure 12/A, B).
For air baffle assembly, install point C, D, E, F with
Ø6mm drill and Ø6mm plastic dowels (Figure 12).
Assemble cooker hood's body (Figure 8).
(Figure 13)
1. Flap pin socket
2. Flap pin
15 / EN