Stihl RE 100.0 PLUS CONTROL Gebrauchsanleitung Seite 43

17 Troubleshooting
Fault
The pressure washer
switches off while in
operation.
The high-pressure
pump repeatedly
switches on and off
without squeezing the
spray gun trigger.
The working pressure
fluctuates or drops.
The shape of the
water jet has chan‐
ged.
Detergent is no lon‐
ger sucked in.
Connections with
pressure washer,
high-pressure hose,
spray gun or spray
lance are stiff.
The LED "BATTERY
INDICATION" flashes
red.
The activation key
flashes green.
0458-004-9621-B
Cause
The plug of the connecting cord or
extension cord has been pulled out of
the socket.
The circuit-breaker (fuse) or the resi‐
dual current circuit breaker has trip‐
ped. There is an electrical overload or
a fault in the circuit.
The fuse rating of the socket is too
low.
The electric motor is too warm.
There is a leak in the high-pressure
pump, high-pressure hose or spray
attachment.
There is not enough water.
The nozzle is blocked.
The water intake screen or water filter
is blocked.
The high-pressure pump, high-press‐
ure hose or spray attachment is lea‐
king or faulty.
The nozzle is blocked.
The nozzle is worn.
The detergent container is empty.
The filter in the detergent bottle is dirty. ► Rinse out the filter under running
The gaskets of the connections have
not been greased.
The batteries in the control panel are
empty.
The connection between the pressure
washer and the control panel no longer
exists.
Remedy
► Plug in mains plug of connecting
cord or extension cord.
► Look for cause of tripping and
remedy it. Engage circuit-breaker
(fuse) or the residual current circuit
breaker.
► Switch off other loads connected to
the same circuit.
► Plug the connecting cable into a
socket with the correct fuse rating,
18.1.
► Allow the pressure washer to cool
for 5 minutes.
► Clean the nozzle.
► Ask a STIHL servicing dealer to
inspect the pressure washer.
► Open water tap fully.
► Make sure that a sufficient quantity
of water is available.
► Clean the nozzle.
► Clean water intake screen and water
filter.
► Ask a STIHL servicing dealer to
inspect the pressure washer.
► Clean the nozzle.
► Fit a new nozzle.
► Fill the detergent bottle with cleaning
agent.
water.
► Lubricate the gaskets.
► Install new batteries in the control
panel.
► Switch off the high-pressure washer.
► Reduce the distance between the
spray gun and the pressure washer.
► Switch on the pressure washer and
the control panel.
English
17.2
43