Assembling The Pressure Washer; Installing The Batteries - Stihl RE 100.0 PLUS CONTROL Gebrauchsanleitung

English
► If using a water filter: Check the water filter for
dirt and clean it if it is dirty,
► Set up the pressure washer on a firm and level
base, where it will not slide or tip over.
► Unroll high-pressure hose from hose reel,
10.2.
► Connect spray gun,
► Fit spray lance,
► If using a nozzle: Attach the nozzle,
► If using a detergent: Using detergents and the
detergent bottle,
► Connect water supply,
► Connect pressure washer to power supply,
8.
► If it is not possible to carry out these steps: Do
not use the pressure washer. Consult a STIHL
servicing dealer.
6 Assembling the pressure
washer
6.1 Assembling the high-pressure
washer
Installing handle with hose reel
2
3
► Slide the handle (1) onto the holder (2).
► Insert screws (3) and tighten.
Connecting the hose reel
2
1
► Fit the connecting piece (1) into the coupling
(2).
The connector (1) engages with an audible
click.
► Secure the cover (3) with the screw (4).
34
14.4.
6.3.
6.4.
6.5.
10.6.
7.
1
3
Inserting nozzles
1
► Insert 3-in1 nozzle (1).
6.2

Installing the Batteries

1
► Press the locking button (1).
► Remove control panel (2).
► Open the retaining latch (3).
► Remove the cover (4).
5
► Insert the batteries (5) into the control panel
(2) according to the polarity- (+/-).
► Close cover (4).
► Insert the control panel into the spray gun.
The control panel engages with an audible
click.
4

6 Assembling the pressure washer

2
4
2
4
0458-004-9621-B
3