Sartorius BioPAT Xgas Betriebsanleitung Seite 22

Installation
22 Operating Instructions BioPAT
Connecting to Biostat
Connect the analog signal outputs of the
t
BioPAT Xgas to the analog inputs on the
®
control tower of the Biostat
Take the analog signal cable.
t
Connect the cable plug labeled "Xgas" to
t
the right-hand socket of the BioPAT
Connect the cable plug labeled "Ext. Sig.
t
A1/B1" or "Ext. Sig.C1/D1" to the "Ext.
Sig.-A1/B1" or "Ext. Sig.-C1/D1" socket of
the Biostat
®
signal configuration for off-gas analysis.
Xgas
®
B (Serial No. > 1000)
®
B as follows:
®
B depending on the DCU
Xgas.
®