Unboxing And Assembling - Sartorius BioPAT Xgas Betriebsanleitung

Installation
Fig. 4a: Unboxing
D E
C B
Fig. 4b: Preparing the
assembling (B) Spare kit 2:
SB-20-02-0001, Spare part kit
for BioPAT Xgas
®
14 Operating Instructions BioPAT
− For sterilizable-in-place (SIP) bioreactors:
installation kit already attached to the biore-
actor frame.
− Signal transmission cable to the BioPAT
on the control unit.
− When delivered with the external power
supply, the male connector must match the
power connection in laboratory. The delivery
contains the matching plug adapter.
− A replacement BioPAT
pack can be ordered from Sartorius Stedim
Biotech (SB-20-02-0002), see "Fig. 5: Cable
set included".
4.1.1

Unboxing and assembling

The flow adapter of the BioPAT
pre-assembled and will be delivered in a small
box together with the BioPAT
Before the installation, it must be connected to
the BioPAT
For the assembling you will need (fig. 4b):
A
1. The BioPAT
2. The TORX T20 screwdriver (D)
3. The mounting base plate (C)
4. The flow adapter (E)
5. Bag with 2 flat head screws M4x6 TORX for
the wall mounting and 4 screws M4x16 TORX
for the flow adapter (B).
6. Bag with flow path filter set BioPAT
Xgas power supply kit
®
Xgas.
®
Xgas (A)
®
Xgas
®
Xgas
®
Xgas is not
®
Xgas (fig. 4a).
®
Xgas (B).
®