Sartorius BioPAT Xgas Betriebsanleitung Seite 20

Installation
20 Operating Instructions BioPAT
Connecting to Biostat
Connect the analog signal outputs of the
t
BioPAT Xgas to the analog inputs on the
®
Control Tower of the Biostat
Take the analog Y signal cable.
t
Connect the plug of the Y cable labeled
t
"Xgas" to the right female connector of the
BioPAT Xgas.
®
Connect the plug of the Y cable labeled
t
"Ext. Sig.-A" to the female connector
"Ext. Sig.-A1/2" of the Biostat
Connect the plug of the Y cable labeled
t
"Ext. Sig.-A" to the female connector
"Ext. Sig.-B1/2" of the Biostat
Xgas
®
B (Serial No. ≤ 1000)
®
B as follows:
®
B.
®
B.
®