Setup; Assembly - Sartorius BioPAT Xgas Betriebsanleitung

4.2
Danger of damage to the control and supply unit
of the bioreactor!
IMPORTANT
The BioPAT
Do not place the module on the control and
t
supply unit of the bioreactor and do not
fasten it to its side panels. The housing panels
cannot carry the weight of the BioPAT
4.3
When using bioreactor bench-top systems,
mount the BioPAT
with non-slip rubber feet.
Observe the lengths of the cables and
t
connection lines.
Place the BioPAT
t
next to the bioreactor so that you can
comfortably connect all equipment.
Mounting the BioPAT
t
surface is possible with the approriate 6.6 mm
screws.
When using sterilizable-in-place (SIP) bioreac-
tors, the BioPAT
bioreactor frame using an installation kit.
Avoid contact between the signal cable and
t
the outer surface of the vessel.
Ensure that no hot steam is directed at the
t
sensor and signal cable.

Setup

Xgas module weighs approx. 3 kg.
®

Assembly

Xgas module on a flat surface
®
Xgas on the work table
®
Xgas module is attached to the
®
Operating Instructions BioPAT
Installation
Xgas.
®
Xgas on a fixed vertical
®
Xgas
®
17