Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Risk of accident if the pretensioning of the quick-release is too low. The
wheel can become loose while riding.
-> Always tighten the quick-release until the tensioning lever leaves
a force-induced imprint on the palm of your hand when folding it down.
6.6.5. Fitting the rear wheel
•
Remove (when inserted) the yellow transport lock from between the brake pads.
•
Lift the belt without twisting onto the rear pulley and place the rear wheel in the
frame drop-outs. Make sure that the cables are not trapped and that the brake
disc slides between the brake pads.
•
Place the rear wheel in the dropouts of the frame. Make sure that the cables
are not pinched in the process and that the brake disc slides between the brake
pads.
enviolo shifting system:
•
Push an external tab washer onto each end
of the hub axle. The ridges of the external
tab washers must point towards the frame.
The right-angled tab must reach into the
frame drop-out.
•
Screw the axle nuts onto both sides and tighten
them to a tightening torque of 30-40 Nm.
•
Reinstall the control cable ends provided
with a pull-stop device or pull-stop snap lock in the hub interface.
•
If you increased the shift cable clearance to make it easier to remove the rear
wheel, you will need to readjust it now.
Rohloff E-14:
•
Turn the hub so that the Rohloff support block
is aligned with the opening of the dropouts.
•
Thread the rear wheel into the frame from be-
low. Make sure that the brake disc slides be-
tween the brake pads and the support block
slips into the dropout.
125
Werbung
Inhaltsverzeichnis
