Removing/Installing The Battery - HNF-NICOLAI UD3 All-Terrain Originalbetriebsanleitung

2.1. Removing/installing the battery
The charger is not protected against moisture (IP40).
-> Do not charge the battery in a humid environment, e.g. rain.
The battery can be charged by plugging in the charger as follows:
1. in the installed state on the vehicle via the charging socket (on the head tube)
2. by plugging the charger into the removed battery.
You can interrupt charging at any time by disconnecting the charger. The
charger switches off automatically when the battery is fully charged.
With dual batteries (only XD3), the two batteries installed on the bike may
only be charged with one charger.
→ Remove the external PowerPack and charge it separately, if you want to
charge the two batteries in parallel.
Always switch the battery/e-bike system off when inserting the battery or
removing it from the frame.
Removal:
• Turn the key in the battery lock clockwise.
The battery is thus unlocked and sits into the
retaining device.
• Press the clip of the retaining device with your
finger. The battery is now freely removable.
XD3 only: When removing the battery, always hold one hand under the
upper part of the battery to prevent the battery from falling out.
Installation:
• Place the bottom of the PowerTube battery with the contacts in the bottom
bracket on the frame.
• Turn the key in the battery lock clockwise to open the lock and hold the key
twisted.
• Press the battery upwards until it clicks into place.
• Check that the battery is firmly in place and remove key before riding.
78