Fitting The Front Wheel; Fitting The Rear Wheel - HNF-NICOLAI XF3 Adventure Originalbetriebsanleitung

Maintenance
• Use tyre levers to lift the other side of the tyre onto the rim.
• Screw the knurled nut onto the valve until it touches the rim.
• Inflate the inner tube with 3 bar so that the tyre sits evenly on the rim. A „pop-
ping" sound is normal.
• Then reduce the pressure to the desired level (see section 3.1.).
• Screw the valve cap onto the valve.
6.6.4. Fitting the front wheel
• Remove (if inserted) the transport lock between the brake pads.
• Carefully thread the front wheel into the fork. Make sure that the brake disc
slides between the brake pads.
• Push the removable axle into the fork and hub.
• Tighten the axle clockwise with the quick release lever. At the end, fold the
tension lever down.
Risk of accident if the quick-release axle in the front wheel is not tighte-
ned firmly.
→ Always tighten the quick-release firmly enough so that the tension
lever leaves a force-related imprint in the palm of your hand when you
fold it up.
6.6.5. Fitting the rear wheel
Hold the rear wheel near the dropouts and carefully lift the belt onto the rear
pulley.
• Turn the hub so that the Rohloff support
block is in alignment with the opening of
the dropouts.
• Thread the rear wheel into the frame from
below. Make sure that the brake disc slides
between the brake pads and the support
block into the drop-out.
• Close the quick release. When closed, the
lever should be horizontal.
120