Side Stand; Ergonomic Setting; Adjusting The Saddle Position And Tilt - HNF-NICOLAI UD3 All-Terrain Originalbetriebsanleitung

2.10. Side stand

Observe the following points when handling your side stand:
The stand may break if you sit on the vehicle when the stand is folded out.
-> Do not sit on the vehicle with the side stand folded out.
Driving with the side stand folded out can lead to a fall. Pushing the vehicle
backwards with the side stand unfolded can cause the stand to jam on the
crank.
→ Fold in the stand before starting to ride.
3. Ergonomic setting
3.1. Adjusting the saddle position and tilt
The optimal horizontal position of the saddle can
be determined by the knee plumb line. The knee
plumb line is the vertical line from the front of the
knee down and should ideally pass through the
pedal axle or just in front of it.
You can determine the knee plumb line by means
of a string with a weight and a helper.
Sit on the vehicle in the position shown above with horizontal crank arms and let
a second person determine the knee plumb line.
To adjust the saddle position and tilt, loosen the
two Allen screws of the saddle clamp, which are
located in front of and behind the seatpost under
the saddle.
You can now move the saddle horizontally and
adjust the tilt.
Set the tilt of the saddle horizontally or with the saddle tip inclined downwards
slightly. Tighten the screws with the nearby mentioned torque.
84