Inserting The Battery Pack; Removing The Battery; Appendix; Technical Specifications - Werock Rocktab U200 Betriebsanleitung

Power supply of the battery charger
To power the battery charger:
1.
Connect the AC adapter with power cord to the charger.
2.
The charger will beep when power is detected (buzzer is off by default), and the LED indicator will
turn RED to indicate that the battery charger is ready for use.

Inserting the Battery Pack

Safety Precautions

Do not operate the charger with a damaged cable or plug. Have the cable replaced immediately.

Use appropriate adapters to connect the charger to the wall outlet.

Always unplug the charger when not in use.

Do not expose the charger to rain or snow.

NEVER charge a frozen battery. If the battery fluid (electrolyte) is frozen, move it to a warm place to
thaw before charging.

Make sure the room where the battery is being charged is well ventilated.

Do not get the battery wet or immerse it in water.

The battery should be charged at least every three months to avoid shortening the battery life.

Do not squeeze or puncture the battery to prevent electrolyte leakage from the lith
To insert the battery.
1.
Place the battery connector down and align the edge of the battery with the side of the charging
slot. Insert the battery until the battery connector is firmly connected to the charging pins.
2.
The charging station will beep when the battery is properly detected (the buzzer is off by default).
The LED indicator will then turn YELLOW and the charger will automatically begin charging.
The estimated charging time for a full charge is between 3 and 6 hours, depending on the size of the battery.
The estimated charging time may change depending on the condition of the battery.

Removing the Battery

To remove the battery:
1.
The LED indicator will turn GREEN when the battery is more than 95% charged.
2.
The charger will stop charging when the battery is fully charged.
3.
Please remove the battery directly.

Appendix

Technical specifications

Technical Specifications Rocktab U212
Physical characteristics
Rocktab U200 User Manual
145 / 151