Herunterladen Inhalt Inhalt Diese Seite drucken

Werock Rocktab U200 Betriebsanleitung Seite 139

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

I cannot connect to another device with Bluetooth.
Make sure that both devices have Bluetooth turned on (for the tablet, use HotTab to check if Bluetooth is
turned on).
Make sure that the distance between the two devices is max. 10 meters and that there are no walls or
major obstacles between the devices.
Make sure that both devices are turned on and configured to be detected.
Make sure that both devices are compatible.
The GPS application cannot find my location
Make sure that the GPS in HotTab is turned on.
Make sure the GPS receiver and location sensor are enabled in the control panel.
The tablet may be out of range of reception.
Move the tablet outside or closer to a window.
Check for interference in your environment, such as microwave ovens, cordless phones. Move the tablet
away from objects that cause interference.
I have a problem with GPS accuracy.
If you are using the GPS function, we recommend disabling the barcode reader in HotTab to reduce
interference.
No sound is output
Adjust the volume of the tablet by pressing the volume rocker.
If you are using an external audio device, make sure the cable is connected properly.
I can't project the tablet's display to another monitor
Make sure the VGA driver is installed.
Make sure that the selected output setting is correct.
The barcode scanner does not send a laser beam and does not seem to work
Make sure the barcode scanner is turned on in HotTab Utility.
In Windows, make sure the barcode reader is set to COM 15 so HotTab can drive the barcode reader
hardware.
The barcode scanner emits a laser beam but does not read the barcode
presented to it
Adjust the distance between the device's barcode scanner and the barcode you want to scan.
Make sure that the barcode type is enabled on the tablet. To enable/disable a specific barcode type, go
through the Barcode Scanner Configuration section.
RFID scanner does not seem to work
In Windows, make sure the RFID hardware is set to COM 3 port.
Rocktab U200 User Manual
139 / 151

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis