Werock Rocktab U200 Betriebsanleitung Seite 104

Rocktab U200 User Manual
Installation battery
Rocktab U214
To insert the supplied standard battery:
1. Disconnect all cables connected to the tablet computer.
2. Turn the tablet computer over so that the back is facing up.
3. Locate the battery lock slide and slide it to the "Unlocked" position.
4. Locate the battery unlock slide, which is spring-loaded. Pull it back and hold it in place.
5. Insert the battery on the terminal pin side first, then lower the battery into the battery compartment.
6. Continue to hold the battery release slide until the battery is fully inserted.
7. Make sure the battery is fully lowered into the compartment before releasing the battery release slide.
8. The battery will lie flat against the case when fully inserted.
104 / 151