Werock Rocktab U200 Betriebsanleitung Seite 103

4. Close the protective I/O cover.
To remove the micro SD card:
1. Open the protective I/O cover by pulling out the latch.
2. Briefly press the micro SD card to unlock it.
3. Pull out the micro SD card.
Installation battery
Rocktab U212
To install the standard battery:
1. Turn the tablet over with the back facing up.
2. Insert the battery with the side with the connector pins first, and then lower the battery into the battery
compartment. Make sure the battery is fully lowered into the compartment. Once fully inserted, the
battery release slide will lock automatically. The battery will lie flat in the case once fully inserted.
3. Slide the battery lock to the "Locked" position.
To remove the battery:
1. Shut down the tablet (or put it into sleep mode). Turn the tablet computer over with the back facing up.
2. Slide the battery latch to the unlocked position.
3. Pull the spring-loaded battery release slide upward and hold it.
4. Lift the battery out using the opening on the side of the battery compartment.
Rocktab U200 User Manual
103 / 151