Werock Rocktab U200 Betriebsanleitung Seite 121

Data Matrix
PDF 417
Micro PDF 417
Codablock A
Codablock F
2D
Maxicode
QR Code
Aztec
Composite Code
Han Xin
Changing the default setting of symbologies or the advanced setting.
There are two methods to change the default setting of symbologies
settings:
Method (1). Click Symbologies at the top, then you can reset the Symbology back to default setting or
make advanced setting by category. After setting, click the "Save to Device" on the sidebar.
Method (2). Click the reset to default button on the sidebar as shown in the figure:
Important: The "Reset to default" button, resets all settings to default.
If the N660X bar code scanner loses connection to the system, scan the bar codes below using the
following steps.
1.
Scan the USB HID barcode:
Rocktab U200 User Manual
121 / 151
Activated
Activated
Activated
Not Active
Not Active
Not Active
Activated
Activated
Not Active
Not Active
or other advanced