Installing The Memory Card; Installing The Battery - Werock Rocktab U210 Bedienungsanleitung

Installing the memory card

Your tablet supports additional memory with an optional micro SDXC card.
To install the micro SDXC card:
1. Open the protective cover (number 5 in the diagram).
2. Insert the Micro-SDXC card into the slot with the contacts facing the back.
3. Press on the card to make sure it is seated properly.
4. Close the protective cover.
To remove the micro SD card:
1. Open the protective cover (number 5 in the diagram).
2. Press the micro SD card briefly to unlock it.
3. Pull out the micro SD card.

Installing the battery

To install the battery, proceed as follows:
1.
Unlock the two battery lock tabs (number 4 in the controls and indicators diagram) marked 1. When
these are unlocked, you will see a red mark.
2.
Unlock the battery cover tab marked 2. When these are unlocked, you will see a red mark.
3.
Now slide the battery cover towards the battery lock tabs. Above the lid (number 5 in the operating
and display elements diagram) you will find an indicator of which position the lid is in.
4.
Now you can remove the lid.
5.
Insert the battery as indicated on the battery and slide it to the right.
6.
Now place the battery cover back on the device so that the indicator above the cover points to the
open lock.
7.
Press the two arrows on the battery lid and slide the lid to the right.
8.
Lock the battery lid tab marked 2. When locked, you will see a green mark.
9.
Lock the two battery cover tabs (number 4 in the Controls and Indicators diagram), which are
marked 1. When these are locked, you will see a green mark.
To remove the battery, proceed as follows:
1.
Unlock the two battery lock tabs (number 4 in the Operating and Display Elements diagram)
marked 1. When these are unlocked, you will see a red mark.
2.
Unlock the battery cover tab marked 2. When these are unlocked, you will see a red mark.
3.
Now slide the battery cover towards the battery lock tabs. Above the lid (number 5 in the operating
and display elements diagram) you will find an indicator of which position the lid is in.
4.
Now you can remove the lid.
5.
Slide the battery in the direction of the battery lock tabs.
6.
Pull the battery out with the tab attached to the battery.
7.
Now place the battery cover back on the device so that the indicator above the cover points to the
open lock.
8.
Press the two arrows on the battery lid and slide the lid to the right.
9.
Lock the battery lid tab marked 2. When locked, you will see a green mark.
10.
Lock the two battery cover tabs (number 4 in the Controls and Indicators diagram), which are
marked 1. When they are locked, you will see a green mark.
Rocktab U210 User Manual
57 / 64