Using The Device - Werock Rocktab U200 Betriebsanleitung

1 19 V DC charging socket
Connection of the battery charging
station to the power supply unit
2 Battery charging station connector
Connects up to three battery charging
stations to each other.
3 Buzzer
Indicates a warning in the event of a
charging error:
Single short beep: power input detected /
battery pack detected.
Repeating double beeps: charging error.
Connecting battery charging stations together
1.
Before connecting the charging stations together, please make sure the direction is as below. Align
the tabs on the sides and gently push down on the charger to lock the other charger.
2.
Make sure the chargers and the connectors on the side are well connected. There should be no
obvious gap between the chargers.
The charger can only charge up to three battery chargers (six batteries) due to the adapter power.
Setting the buzzer
The default setting for the built-in buzzer is OFF. To activate this feature or adjust the volume of the buzzer,
please use the switch on the bottom of the charger.
Switch
3,4
1,2
2,4
1,3

Using the device

Rocktab U200 User Manual
4 LED display
Indicates the current charging status of the
battery:
Lit red: Battery charger is on and ready to
charge.
Yellow: Charging in progress.
Green: Battery capacity is more than 95%
full.
Flashing red: Error during charging.
5 2 x Battery charging bay
Description
Mute
Maximum volume
Medium volume
Minimum volume
144 / 151