Werock Rocktab U200 Betriebsanleitung Seite 120

Host Notification Mode
Snap and Ship mode
Setting the 1D/2D Barcode Scanner Symbologies
The barcode scanner is shipped with the default settings shown below. If the default setting matches the
usage, setting symbologies is not required.
Default settings for symbologies:
Symbology
UPC-A
UPC-E
EAN/JAN-8
EAN/JAN-13
UPC-E1
UPC-A/EAN-13 Extended Coupon Code
GS1 DataBar Omni-Directinal
GS1 DataBar Limited
GS1 DataBar Expanded
Code 39
Code 128
ISBT 128
GS1-128
Interleaved 2 of 5
Linear
Matrix 2 of 5
NEC 2/5
IATA 2/5
Code 2/5
Codabar
Code 93
Code 11
MSI
Telepen
Trioptic Code
Postal Code
Planet Code
Korea Post
China Post
Australian Post
Rocktab U200 User Manual
Host notification mode bypasses the decoder and notifies the host that there has
been a hardware trigger pull. been a hardware trigger pull. In host notification mode,
it is up to the host to initiate an image snap and/or an image ship command. It is
also up to the Host to change to a different trigger mode.
Snap and Ship mode, allows you to bypass the decoder and send an image directly
to the host. In this mode, one image at a time is captured and sent with each trigger
pull instead of being sent to the decoder. Snap and Ship is useful if you are using
your own decoder.
120 / 151
Standard Setting
Activated
Activated
Activated
Activated
Not Active
Not Active
Activated
Activated
Activated
Activated
Activated
Not Active
Activated
Activated
Not Active
Activated
Not Active
Not Active
Activated
Activated
Not Active
Not Active
Not Active
Not Active
Not Active
Not Active
Not Active
Not Active
Not Active