Installation; Removing The Front Panel; Mounting The Appliance - STIEBEL ELTRON LWZ 180 Bedienung Und Installation

INSTALLATIoN

Installation
10. Installation

10.1 Removing the front panel

Remove the front panel before removing the appliance from the
pallet, to avoid damaging the casing.
2
1
1 Fascia
2 Front panel fixing screws
The fascia is fastened to the appliance with locking tabs.
f To disengage the locking tabs, press the grip areas on the
fascia sides.
f Remove the fascia from the appliance.
f Undo both screws securing the front panel at the top of the
appliance.
f Carefully push the front panel upwards by a small amount to
release it from the hooks on which it is engaged.
1 Plug on cable from programming unit to appliance
f Carefully raise the front panel by a small amount on the
right-hand side.
www.stiebel-eltron.com
f On the appliance, pull out the plug connecting the program-
ming unit with the appliance.

10.2 Mounting the appliance

Material losses
!
If the unit is not mounted horizontally, condensate cannot
2
drain properly. Condensate escaping in an uncontrolled
manner can damage the floor or items in the vicinity of
the unit.
Material losses
!
f Check whether the wall can bear the weight of the
f Use appropriate rawl plugs and screws suitable for
f Remove the wall mounting bracket from the appliance.
f Secure the wall mounting bracket to the wall with four
screws. The text "TOP" must be at the top. The wall mounting
bracket must be horizontal.
f If necessary, screw the star grips included in the standard
delivery into the back of the appliance at the bottom to act as
spacers.
f Fit the appliance onto the hooks of the wall mounting
bracket.
f If the appliance is not hanging horizontally, screw the previ-
ously fitted star grips acting as spacers in or out by a small
amount.
1
LWZ 180 | LWZ 280 | LWZ 180 Enthalpie | LWZ 280 Enthalpie |
appliance.
the wall structure to attach the rail.
47