Safety Device; Handlebar Assembly - Stiga SILEX 103 B Bedienungsanleitung

6 During the machine transport and all the maintenance, cleaning, equipment change operations, the engine must be switched off.
7 Before leaving the machine, please switch the engine off.
8 Do not switch the machine on in closed rooms/areas where you can have carbon monoxide exhalations.
9 WARNING !! The petrol/gasoline is highly inflammable: Don't fill the tank neither in closed areas, nor when engine is on, don't smoke and
be careful to the petrol/gasoline loss from the tank. In case of leak, don't try to switch the engine on but move the machine away from the area
in order to avoid ignition source until the gasoline vapours fade away. Re-place the tank caps and the gasoline box.
10 Keep attention to the exhaust pipe. The parts near the pipe can reach 80°C.
Replace the defective and/or worn out silencers Burn hazards !!!.
11 Don't use the motor cultivator on steep slopes: it could overturn!. On slope it is recommended to work crosswise, neither in slope nor in
descent and be vary careful during any change of direction.
12 Before putting the machine into operations, check it visually and make sure all the accident prevention measures are working. It is absolutely
forbidden to exclude and/or to tamper with them.
13 In case the machine is incorrectly used, and/or the repairs are performed by non-authorized technical staff, and/or fitted by non-original spare
parts: any use other than that described above is prohibited and will involve the cancellation of the warranty and the refuse all responsability
from the manufacturer.

SAFETY DEVICE

the machine stopping on the single or reverse speed position, to the release of the control lever, furthermore such device avoids the reverse speed
insertion if the single speed is on.
WARNING ! If the machine is on reverse speed the rotavators are automatically stopping.
Wheels insertion device on 3 positions : (Fig.2)
The motor cultivator is provided with a special device called "FORK 3 POSITIONS"
On position 1 (free) the wheel turns free on the shaft in order to let the machine to move even if the engine is not working;
On position 2 (blocked) the wheel is working with the shaft, working as on motion, i.e. ready to start working, such position is the most common
used;
On position 3 (semi-differential unit) the wheel can perform about a half-turn turning on the shaft, in order to allow turns.
WARNING ! All the works on the fork must be performed when the engine is stopping .
MOTORCULTIVATOR ASSEMBLY
The motorcultivator is delivered to destination, partially assembled in its own packaging, unless otherwise agreed.

Handlebar assembly

the chassis screwing down the screws and the washers (5 and 6) on both sides. ATTENTION: during the handlebar assembly the speed control and
accelerator cables have to be spread out.
Rotavators cover assembling
7
(2) and fix them with the screws (3) and the nut (4). Unscrew the 6 pcs. screws (5) on the frame seating. Please be careful about this operation and
leave the screws (6) fixing the support (7) slightly turned out in order to allow an easier assembling. Then put the cover (8) in the right position and taking
All the motorcultivators are equipped with an accident prevention device. Such device causes the clutch release and
(Fig.3) Fix the handlebar (fig. 3 part. 1) to the support (2) using screws (3) washers and nuts (4). Then fix the support to
(for cultivating width 60 cm. only) (Fig. 11) Insert the expanding parts (part 1) at the bottom of the rotavators