Safety Instructions - Stiga TITAN Road kit Montageanleitung

EN
1 GENERAL
This symbol indicates CAUTION. Seri-
ous personal injury and/or damage to
property may result if the instructions
are not followed carefully.
You must read these instructions for use
and the machine's safety instructions
and instructions for use carefully.
1.1 Symbols
The following symbols appear on the machine.
They are there to remind you of the care and atten-
tion required in use.
This is what the symbols mean:
Warning!
Read the instruction manual and the safety
manual before using the machine.
1.2 References
The figures in these instructions for use are num-
bered 1, 2, 3, etc.
Components shown in the figures are marked A, B,
C, etc.
A reference to component C in figure 2 is written
"2:C".

2 SAFETY INSTRUCTIONS

• Please read through these instructions carefully.
Learn all the controls and the correct use of the
unit.
• Fit all cables according to the instructions.
Loose cables can cause wear and vibration
damages.
• Protect all cables from moving parts on the
machine. Friction can cause wear damages.
• Check regularly that the cable insulation is
intact and that the above mentioned is fulfilled.
3 DESCRIPTION
3.1 General
The accessory kit is intended for use on GGP's
machines, Stiga Titan, to fulfill the demands for
driving on public roads.
The accessory kit comprises the following
functions:
• Flashing direction indicator
• Dimmed headlights
• Backlight
• Licence plate illumination
• Signal
• Socket for trailer
16
ENGLISH
3.2 Delivery
The delivery contains the following parts.
Item Detail
A Headlight (dimmed) with built
in direction indicator.
B Attachment for headlight
C Backlight with direction
indicator.
D Licence plate illumination
E Rear ramp
F 7-pole trailer socket
G Fuse terminal with plate.
H Control for all functions.
I Control bracket
J Signal horn
K Direction indicator relay
L Light relay
M Rear cable harness
N Front cable harness
O Bundle strip
P Set mounting details; Screws,
nuts and washers
Q Sign, 25 km/h
R Reflex to be fitted rear
4 ASSEMBLY
Before carrying out the assembly work,
the power must be cut using the main
switch. Risk for shortcut and fire.
4.1 Main switch
Cut the power using the main switch. See fig. 1.
4.2 Headlight
Assemble the headligft according to the
instructions below. See also fig. 2.
1. Assemble the headlight attachments (2:B) to the
protective frame with two screws and two nuts
for each attachment.
2. The headlights shall be fit with the electrical
terminals (3:Y) inwards. Do not tighten until
the light adjustment is done.
4.3 Rear lights with ramp and cable
hole
1. Remove the upper engine casing and drill a hole
according to the drawing in fig. 4.
2. Refit the casing and assemble the ramp (5:E) in
the rear screws.
Number
2
2
2
2
1
1
1
1
1
1
1
1
1
15
1
3
2