General Power Tool Safety Warnings; Work Area Safety; Electrical Safety - Parkside PAR 12 A1 Originalbetriebsanleitung

Total vibration values (vector total of three
directions) determined in accordance with
EN 62841:
Screwing
Uncertainty
NOTE
► The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with a
standardised test procedure and can be used
for comparison of the power tool with another
tool .
► The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate .
WARNING!
► Depending on the manner in which the power
tool is being used, and in particular the kind
of workpiece being worked, the vibration and
noise emission values can deviate from the
values given in these instructions during actual
use of the power tool .
► Try to keep the vibration load as low as
pos sible . Measures to reduce the vibration
load are, e .g . wearing gloves and limiting the
working time . Wherein all states of operation
must be included (e .g . times when the power
tool is switched off and times where the power
tool is switched on but running without load) .
PAR 12 A1
General power tool safety
warnings
a < 2,5 m/s
2
h
K = 1 .5 m/s
2
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool .

1 . Work area safety

a) Keep work area clean and well lit.
b) Do not operate power tools in explosive atmos­
c) Keep children and bystanders away while

2 . Electrical safety

a) Power tool plugs must match the outlet. Never
b) Avoid body contact with earthed or grounded
WARNING!
► Read all safety warnings, instruc­
tions, illustrations and specifications
provided with this power tool.
Failure to follow all instructions listed
below may result in electric shock,
fire and/or serious injury .
Cluttered or dark areas invite accidents .
pheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes .
operating a power tool. Distractions can
cause you to lose control .
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded)
power tools. Unmodified plugs and matching
outlets will reduce risk of electric shock .
surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of
electric shock if your body is earthed or
grounded .
GB │ MT │ 39 ■