Technical Specifications; General Power Tool Safety Warnings; Work Area Safety - Parkside PWBS 180 B2 Originalbetriebsanleitung

Technical specifications
Rated voltage
Rated power consumption 1050 W
Rated speed
Rated capacity
Thread size
Protection class
Noise and vibration data
Noise measurement value determined in accord-
ance with EN 60745. The A-rated noise level of
the power tool is typically as follows:
Noise emission value
Sound pressure level
Uncertainty
Sound power level
Uncertainty
Wear ear muffs!
Total vibration value
Surface sanding
Uncertainty
NOTE
► The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure and can
be used for appliance comparisons. The spec-
ified vibration emission value can also be
used to make an initial exposure estimate.
PWBS 180 B2
230 V ∼, 50 Hz (AC)
n 410−1900 rpm
Ø 180 mm
M14
II / (double insulation)
L = 90.53 dB(A)
PA
K = 3 dB
L = 101.53 dB(A)
WA
K = 3 dB
a = 6.3 m/s 2
h, DS
K = 1.5 m/s 2
WARNING!
► The vibration level varies depending on the
use of the power tool and may be higher
than the value specified in these instructions
in some cases. Regular use of the power tool
in this way may cause the user to underesti-
mate the vibration. Try to keep the vibration
loads as low as possible. Measures to reduce
the vibration load are, e.g. wearing gloves
and limiting the working time. Wherein all
states of operation must be included (e.g.
times when the power tool is switched off and
times where the power tool is switched on but
running without load).
General power tool
safety warnings
WARNING!
► Read all safety warnings and all instructions.
Failure to follow the warnings and instructions
may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool.

1. Work area safety

a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b) Do not operate power tools in explosive atmos-
pheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.
GB │ MT │
35 ■