Installing The Reserve Parachutes; Handle / Pod Connection - SUPAIR ACRO4 Betriebshandbuch

Harness User's Manual | ACRO4
Thank you for reading carefully ! We recommend for the initial rescue parachute assembly and installation to be made by a qualified
professional.
Folding and installation of the reserve parachute inside the harness must conform to the specific line guide found in this manual.
Warning before starting the installation procedure
- The handle found to the pilot's right side, extracts the parachute located beneath the seat.
- The handle found to the pilot's left side, extracts the dorsal ( rear ) reserve parachute.
- If only one reserve parachute is installed :
- Right handed pilots : use the pocket beneath the seat.
- Left handed pilots : use the dorsal pocket.
Handle - POD connection
Use the handle ref. : A4S to install the reserve parachute beneath the seat. And the handle ref. : A4B
for a dorsal reserve parachute installation.
The handle must be connected to one of the POD buckles. For a dorsal parachute pocket ins-
1
tallation : use the central loop-strap. For an installation beneath the seat : you can use either
one ( the central loop-strap is mostly used ).
Push the handle through the central loop-strap, and make a « loop to loop » connection with
2
the handle.
3
Tighten securely the "loop to loop" connection.

Installing the reserve parachutes

If you install two reserve parachutes :
- Right handed pilots : install the dorsal reserve parachute first,
then the other inside the container beneath the seat.
- Left handed pilots : install the reserve parachute beneath the
seat first, then the other inside the dorsal reserve parachute
container.
SUPAIR | ACRO4 | page 13