SUPAIR ACRO4 Betriebshandbuch Seite 48

Harness User's Manual | ACRO4
Reserve parachute - Harness connection
If you install only one reserve parachute:
Place the Maillon Rapide® (
1
locking gate toward the top,
facing outward ) and push it
through the bridle loop under
the flap. Place the O ring in
the Maillon and twist it in a
figure 8 configuration.
5
Tuck away the risers excess under the flaps.
If you install two reserves parachutes:
Regarding the second reserve parachute : com-
plete the installation of the first rescue in its
pocket. Repeat the procedure with a new set of
Maillons Rapides®, by overlapping the second
riser set on the initial arrangement. Install first
the reserve parachute to which the handle is
found opposed to your predilection side.
Push the riser through the
2
upper free «8» shaped toric
ring and connect it to the
Maillon Rapide®.
Installing the reserve parachutes
Create a new twisted loop
3
with the O ring before inser-
ting it into the Maillon Ra-
pide®.
Repeat procedures 1,2,3 with
4
an additional O ring for the
connection to the harness.
Tighten the Maillon Rapide®
locking gate securely, with
pliers if necessarily.
SUPAIR | ACRO4 | page 14