Mandatory Extraction Test Procedure - SUPAIR ACRO4 Betriebshandbuch

Harness User's Manual | ACRO4
Installing the reserve parachute inside the dorsale pocket
Place the risers in the left harness sleeve.
1
Then place them over the left flaps and tuck
away the risers and lines length excess at
the bottom of the reserve parachute pocket.
Finally, position the reserve parachute atop
the risers and lines excess.
Tuck away the upper flap
4
inside its neoprene housing
located on the lower flap to
properly close and fasten
the pocket. Last, connect
the reserve parachute
handle to the Velcro® lo-
cated on the left side of the
harness.
Keep the handle outside the pocket. Using
2
a small cord pull loop #1 through grommet
#2, then 5 and 6. Repeat the operation with
loop #3 through grommet #4, then 5 and 6.
3
4

Mandatory extraction test procedure

Have the installation checked by a professional outfit.
Conduct an extraction test every six ( 6 ) months to assure proper system
functionality.
Note :
Conducting and extraction test does not imply deploying the reserve para-
chute which will stay inside its POD.
Installing the dorsal reserve
Close the assembly by sliding the safety pins
3
through the small white loops, then tuck
away the handle strap between the two left
flaps, and secure it by using the sewn strap
at the top of the lower flap
6
1
2
5
Check the completed installation
during a Hang-test.
SUPAIR | ACRO4 | page 20