Bumpair - SUPAIR ACRO4 Betriebshandbuch

Harness User's Manual | ACRO4

BUMPAIR

«Accessing the Bumpair dorsal protector
1
pocket:
Open the rear storage pocket
Unfasten the vertical Velcro®»
The Bumpair only need to be installed once. There is no need to take it out of the harness except in the event of a high intensity
impact and/or water landing : it would then be necessary to check for possible damage, tearing of the fabric, broken seams, etc...
Inspect the integrity of the Bumpair every two years or after each substantial impact
We recommend changing the Bumpair after two (2) strong impacts or every five (5) years of service
«Insert the Bumpair with the thickest
2
section first
Push it to the bottom of the pocket and
check that it is properly installed by
passing your hand between the inner
wall and the Bumpair.»
Accessories Assembly
Fold down the Bumpair top holding
3
pocket located at the upper section of
the backrest, then close the flap and
fasten the Velcro®
SUPAIR | ACRO4 | page 10