Berkel SUPREMA Serie Gebrauchsanleitung Seite 13

clean for correct sharpening.
Remove dirt and grease with
alcohol and a semi-rigid nylon
brush.
REMOVING THE BLADE
WARNING! Use original
!
devices only!
WARNING! Danger of
!
being cut! Use only after
carefully reading the operating
instructions supplied with the
device.
If a blade removal device has
mended that you follow the
relevant operating instructions
provided with your device to
remove the blade.
MAINTENANCE
Blade Sharpening
sharpening depend on the use
Before sharpening:
1. make sure that the machine
is off;
2. position the thickness ad-
justment knob in the safety
position;
3. set the regulating knob for
slice thickness in the safety posi-
tion;
4. pull the meat table all the
way back.
struction:
raise the sharpening unit pro-
180° to position it in the sharp-
the sharpener and start the
blade by pressing the start but-
bringing the wheel in contact
with the blade for about 10/15
seconds. Sharpening and de-
burring occur simultaneously.
Release the lever and stop the
blade motion by pressing the
stop button. Pull the grip to
bring the sharpening unit to
the initial position and lower
the sharpening unit protection
cover (Fig. L).
! WARNING! The sharp-
ening wheel can easily be
removed from the sharpening
tion of the arrow. Keep the
wheel clean for correct sharp-
ening. Remove dirt and grease
- with alcohol and a semi-rigid
nylon brush.
Lubrication
may be necessary to lubricate
the carriage guides. We recom-
mend executing this operation
every 1 month.
free oil (we recommend Vase-
line oil). Do not use vegetable
oil.
struction: 1) move the meat
table towards the operator; 2)
insert the oiler in the special
hole and pour a small amount
of oil; 3) remove the oiler and
slide the carriage 3-4 times.
SERVICE
- No user-serviceable parts are
- and replacement operations
replacement of the sub-basap-
late electrical system compo-
repair and/or re-placement of
similar) shall be executed exclu-
13
sively by personnel authorized
by the manufacturer.
In the event service is need-
slicer to the manufacturer or
to one of the Authorized Ser-
vice Centers. For information
about service centers please
contact us at:
service@berkelinternational.com.
! WARNING! The blade re-
placement is mandatory
- if distance between the edge of
the blade and the internal edge
of the guard exceeds 6 mm.
WARRANTY
AND RESPONSIBILITY
The manufacturer
machines with a limited war-
ranty of 24 months from the
purchasing date. The warran-
ty is extended only to defects
that arise under intended use
conditions and proper use.
The warranty does not cover
defects resulting from faults
- er's incompetence or negli-
than 10% of the nominal value.
not cover components intrin-
the event of evident manufac-
- turing defects.
The manufacturer declines any
direct and indirect responsibil-
- ity coming from:
- failure to observe the instruc-
tions in this manual;
- use which does not conform
tions in the country of instal-
lation;
-
supplies
-
-
-